How To Reverse The Door Swing - Vinotemp VT-46SSDST Service Manual

6.

HOW TO REVERSE THE DOOR SWING

If you want to open the door in an opposite direction, please follow the following instructions.
① Lockup screw
② Lower door hinge
③ Door pivot assembly
④ Right upper door hinge
⑤ Lower door hinge (the same for the left and right)
⑥ Left upper door hinge
Cautions: All removed parts and components must
be kept for later reinstallation of the door.
1. Open the glass door and fasten two lockup screws ① , and support the door pivot towards the glass
door. After taking out the screws, be careful to support the glass door. (as shown in Figure 1)
2. Pull the glass down downwards and remove it, and place the glass door onto the soft gasket to
prevent any scratch to the glass surface.
3. Remove 3 screws from the right side of the door bottom, and 3 screws from the right side of the door
top. (as shown in Figure 2)
4. Remove the hinge for the right upper door ④ . Take out the hinge for the left upper door hinge ⑥ from
the plastic bag of installation instructions, and install it at the left specific position. Then, accordingly
mount the upper door shaft assembly. (as shown in Figure 3)
5. Remove the door pivot ③ from the right lower hinge ③ , and then insert it in the door pivot at the left
lower part of the door front.
6. Turn the glass door at 180°, and then mount it back at its specific location, and lock up the screw ①
using two screws to connect the door pivot ③ assembly and the glass door, and fasten the screws
before door leveling.
12