Installation Instruction - Vinotemp VT-46SSDST Service Manual

10. INSTALLATION INSTRUCTION

Before use of drinks cabinets
l Remove all interior and exterior packing.
l Before connection of the drinks cabinet to power, make it at an upright position for about 2 hours.
l This will reduce the possibility of failure in the refrigerating system arising from the transportation
process.
l Use soft rags dipped with lukewarm clean water to clean the exterior surface.
l This device can be opened from the left or the right. The door opening direction of the device delivered
home is on the left. If you want to open the door from the right, follow the instructions set out in
"Turning the door wing of the device".
Installation of dinks cabinet
l This device is designed as built-in, or dented or freely standalone mounted.
l Place the drinks cabinet on a solid ground enough to support the drinks cabinet. It is required to
adjust your drinks cabinet flat. You can adjust the front leveling foots at the bottom of the drinks
cabinet.
l Put the drinks cabinet far away from direct sunshine and heats sources (such as furnaces, heaters and
radiators). Direct sunshine will affect acrylic coatings, and heat source will increase power
consumption. An extremely cold ambient temperature will result in abnormality in device running.
l Try not to put the device at a damp place.
l Insert the drinks cabinet at a standalone socket that can be easily reached. For power supply and/or
grounding, it is required to directly consult qualified technicians or the authorized product service
center.
l In no case may the air vent located in the front of the device be covered or blocked.
l This device must be mounted on electric, water supply and drainage devices complying with
national and local laws and regulations.
Notice of the built-in cupboard
These devices are designed as built-in installation or freely standalone installation. If you want these
devices to be in a built-in installation, please follow the requirements as set out in the form below.
JC58A2EQ(B)
Model
JC58EQ
Width 30 cm
Depth 59 cm
Height 87.5 cm
Caution
l Use sealed bottles to store drinks.
l Do not make the cabinet overloaded.
l Do not open the door unless it is necessary.
l Do not cover the shelves using aluminum foils or any other airtight materials.
l If the drinks cabinet lies idle for long, we recommend you pull out the device plug. After careful
cleaning, make the door half open so that air will flow to the cabinet to avoid condensation, mildew or
odor.
Opening dimension of the cupboard (minimum)
JC85A1EQ(B)
JC85A2EQ(B)
JC85BEQ
38 cm
59 cm
87.5 cm
JC116A2EQ(B)
60 cm
59 cm
87.5 cm
15
JC145A2EQ2
60 cm
59 cm
82.5 cm