Connecting The Speakers - Samsung 2.0041112184519e16 Instruction Manual

Digital home theater system
Table of Contents

Advertisement

Connecting the Speakers

Connect the supplied speaker system using the supplied speaker cords.
- Make all connections with the power turned off to the unit to protect the speakers.
Check the location of the terminals on the main unit and on the rear of the
1
speakers before connecting the Front, Rear, and Center Speakers.
- Connect the red cord to the red(+)terminal and the black cord to the black(-) terminal.
- Make sure the positive (+) and negative (-) speaker wires are not mixed.
2
Use the supplied audio cord to connect the SUBWOOFER PREOUT on the
rear of the main unit to the LINE IN on the rear of the speaker.
After installation is complete, tie up or taping down long, loose electrical cords.
Ideal Speaker Placement
Center speaker
Front Speakers
Right front
Left front speaker
speaker
Set the front speakers so that their tweeters (high-range) are
aligned at about ear level and at a horizontal angle of 45° to the
Subwoofer
prime listening position.
Center Speaker
Ideally the center speaker should be positioned with its top
surface flush with the front speakers. However, you may place
the speaker either on top or near the bottom of your TV set.
Vibration caused by the center speaker can disrupt the picture
if it is placed directly on the television. Put the center speaker
on a rack or shelf.
Left rear
Right rear
speaker
speaker
Rear Speakers
Set the rear speakers further back, parallel to the walls,
at 60 to 90 centimeters (2 to 3 feet) above prime listening
position ear level.
If the space behind the listening position is insufficient
(i.e., too close to the wall), place the rear speakers facing
each other on either side.
Subwoofer Speaker
Place the subwoofer on the floor near the TV or mount it
on a rack, free from vibration and instability.
Please refer to the KLIPSCH Operation Manual for details on using the speakers.
9
1
Loosen the speaker terminal by
turning it counterclockwise.
1
2
Insert the speaker wire into
the terminal.
3
Tighten the speaker terminal
by turning it clockwise.
Right rear speaker
Left rear speaker
Center speaker
(—)
(+)
(—)
(+)
(—)
(+)
(—)
(+)
(—)
Right front speaker
Left front speaker
1
Press and hold the
1
terminal tab.
2
Insert the speaker cord.
3
Release your finger.
3
2
Subwoofer
LINE IN
R
L/LFE
Audio Cable (supplied)
(+)
2
3
Red
Black
10

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ht-sk6

Table of Contents