Connecting The Speakers - Samsung HT-E456K User Manual

Connections
Installing the Speakers on the Half Tallboy Stand
* HT-E453HK only - Front Speakers
1. Stretch out the speaker cables as shown and arrange it through the
hole of the stand base .
2. When done, use the stand driver to tighten the stand nut as shown.
3. This is the appearance after the speaker is installed. Follow these
steps to install another speaker.
4. If you want to adjust the height of the speaker, loosen two screws
on the rear of the speaker.
5. Pull up the speaker in the arrow direction. Fit the speaker in a height
adjusting hole of your choice.
!
CAUTION : Be careful as an excessive force may result in a physical
damage.
6. Insert two screws clockwise into the hole on the rear of the speaker
using a screwdriver as shown and tighten back 2 screws.
7. This is after the height of the speaker is adjusted.
You can repeat these steps above at any time if you want to
readjust the height.

Connecting The Speakers

1. Press down the terminal tab on the back of the speaker. (HT-E453K/
E453HK/E445K/E456K Only)
2. Insert the black wire into the black terminal (–) and the red wire into the red
terminal (+), and then release the tab. (HT-E453K/E453HK/E445K/E456K
Only)
3. Connect the connecting plugs to the back of the product by matching the
colours of the speaker plugs to the speaker jacks.
In case of HT-E450K
Front Speaker (R)
Surround Speaker (R)
* Refer to page 16¬17 for the speakers of HT-E453K/E453HK/E445K/E456K.
18
English
SPEAKERS OUT
FA NET
(Only For Service)
SURROUND SUBWOOFER SURROUND
Subwoofer
1
3
5
7
Black
Center Speaker
Front Speaker (L)
VIDEO
AUX IN 2
OUT
FM ANT HDMI OUT
OPTICAL
DIGITAL
AUDIO IN
Surround Speaker (L)
2
4
6
Red