Connect Video To Tv; (Your Dvd Player Will Only Play Dvds That Are Labeled With Identical Region Codes.) Connecting The Fm And Am (Mw) Antennas - Samsung 2.0041112184519e16 Instruction Manual

Digital home theater system
Table of Contents

Advertisement

Connect Video to TV

*
Depending on your TV, Component Video input connectors may be marked as DVD Video input connectors.
Composite Video (Good Quality)
Connect the supplied video cable from the VIDEO OUT jack on the back panel of the
system to the VIDEO IN jack on your television.
S-Video (Better Quality)
If you television is equipped with an S-Video input, connect an S-Video cable (not supplied)
from the S-VIDEO OUT jack on the back panel of the system to the S-VIDEO IN jack on
your television.
Component Video (Best Quality)
If your television is equipped with Component Video inputs, connect a component video
cable (not supplied) from the Pr, Pb and Y jacks on the back panel of the system to the
corresponding jacks on your television.
When the Progressive scan mode is selected, the VIDEO and S-VIDEO outputs do not feed
any signals. See page 16 to select Progressive Scan.
11
TV
Composite
Component
S-Video
Video
Video
Connecting the FM and AM
1
If FM reception is poor,
connect an outdoor FM antenna
(not supplied).
FM Antenna (supplied)
Cooling fan (See "About Cooling Fan" below.)
FM antenna connection
1. Connect the FM antenna supplied to the FM 75
COAXIAL terminal as temporary measure.
2. Slowly move the antenna wire around until you
find a location where reception is good, then
fasten it to a wall or other rigid surface.
• If reception is poor, connect an outdoor antenna.
Before attaching a 75 coaxial cable (with a standard
type connector), disconnect the supplied FM antenna.
(About the cooling fan)
A cooling fan is mounted on the rear panel of the center unit to
prevent abnormal temperature inside the center unit, thus assuring
normal operation. The cooling fan automatically starts rotating to
supply external cool air to the inside of the center unit when the
internal temperature exceeds the specified limit.
Antennas
( MW )
2
3
If AM reception is
poor, connect an
outdoor AM
antenna(not
supplied).
AM Loop Antenna
(supplied)
ANTENNA
Snap the tabs on the loop into the
slots of the base to assemble the
AM loop antenna.
AM
antenna connection
(MW)
1. Connect the AM loop antenna supplied
to the AM and
terminals.
2. If reception is poor, connect an outdoor
single vinyl-covered wire to the AM
terminal. (Keep the AM loop antenna
connected).
For safety, observe the following carefully.
• Make sure there is good ventilation around the center unit. Poor
ventilation could overheat and cause damage.
• DO NOT block the cooling fan and the ventilation openings or
holes. (If they are blocked by a newspaper or cloth, etc., the heat
may not be able to escape.)
12

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ht-sk6

Table of Contents