Warning And General Safety Information - Intermatic P1353ME Instruction Manual

WARNINGS AND GENERAL
SAFETY INFORMATION
WARNING
Risk of Fire or Electric Shock
• Disconnect all power before installing or servicing this
control or its connected loads.
• Follow all local electrical and safety codes, National
Electric Code (NEC), as well as Occupational Safety
and Health Act (OSHA).
• If the power disconnect point is out of sight, lock it in
the "OFF" position and tag it to prevent unexpected
application of power.
• The outdoor enclosure, in which the control is
installed, must be grounded.
• Do not exceed the maximum current carrying capacity
of this control.
• Always replace the plastic insulator covering the
terminals before turning power "ON".
• Strip the line and load wires by removing 1/2 inch of
insulation. DO NOT USE ALUMINUM WIRE. Insert
the wire ends under the proper terminal plates and
tighten the screws firmly. Use AWG #10 through #18.
Use COPPER conductors only.
• DO NOT TOUCH circuit board components; contact
can create a static discharge, which can damage the
microprocessor.
• KEEP DOOR CLOSED AT ALL TIMES when not
servicing.
4
Clearing all scheduled ON/OFF
Events Quickly
To clear all schedules, follow the procedure below. This
function is helpful when you want to start your event
programming from scratch and disable all the current
ON/OFF events.
1. Press and hold down the PROG key. The display
time will blink
2. After approximately 5 seconds, the SET CLOCK will
disappear and the display time will stop blinking.
3. You have now cleared all the scheduled ON/OFF
events. Refer to step #8 to set new ON/OFF event
times.
37