Panasonic ER-SB40 Operating Instructions Manual page 12

Trimming height comb attachment
(Trimming height: approx. 1 mm (1/32") to 10 mm (13/32"))
• Actual hair length will be a little longer than the height you set.
► How to adjust the trimming height
Turn the dial and adjust the trimming height
indication mark (a) to the desired height�
Indicator 1
Trimming
mm 1 1.5 2 2.5 3 3.5 4 4.5 5 5.5
height
inch 1/32 1/16 5/64 3/32 1/8 9/64 5/32 11/64 3/16 7/32
(estimate)
Indicator 6
Trimming
mm 6 6.5 7 7.5 8 8.5 9 9.5 10
height
inch 15/64 1/4 9/32 19/64 5/16 11/32 23/64 3/8 13/32
(estimate)
12
ER-SB40_CAN.indb 12

2 3 4 5
7 8 9 10
► Trimming to an even length
Holding the appliance with the power
switch facing outwards, trim by
bringing the blade in contact with
the skin and moving the appliance
against the flow of the beard.
• Hair trimmings may collect inside the
attachment when a large volume of beard is
cut, so discard hair trimmings after each use.
Without the attachment
(Trimming height: approx. 0.5 mm (1/64"))
• The appliance cannot trim hair to lengths less than 0.5 mm (1/64").
► Trimming the downy hair
Holding the appliance with the
power switch facing outwards, trim
by bringing the blade in contact
with the skin�
► Design precise lines
1
Place the blade at a right angle
on the edge of where you want
to make a precise line�
2
Move the blade away and down
from the area you want to leave,
and cut the remaining beard�
2017/07/18 18:04:15