Panasonic ER-SB40 Operating Instructions Manual page 11

When the battery capacity is low "LOW" blinks when
operating the appliance.
The appliance beeps twice after switched off.
You can trim approx. 5 minutes after "LOW" blinks.
(This will differ depending on usage.)
3
Press when finished.
Locking/unlocking the power switch
► Locking the power switch
1. Press for more than 2 seconds.
• The switch lock lamp (
5 seconds and turn off.
• The appliance will stop operating.
2. Release .
► Unlocking the power switch
1. Press for more than 2 seconds.
• The switch lock lamp (
2. Once the appliance starts operating, release
ER-SB40_CAN.indb 11
) will light up for
) will turn off.
.
AC operation
If you connect the AC adaptor to the appliance in the same way as
for charging, and turn on the power, you can use it.
• If the remaining battery is too low, the blades may move slowly
or stop, even with the AC operation. In this case, charge the
battery for 1 minute or more.
• The battery will be discharged, even with the AC operation.
Removing and mounting the attachments
• Take care not to injure hands, etc., with the blade when removing
or mounting the attachment.
• Turn the appliance off.
► Mounting the attachment
Mount the attachment to the main body
until it clicks.
• If the attachment is not attached
correctly, it may shift and end up cutting
too much during use.
► Removing the attachment
Hold the main body securely and remove
the attachment from the main body.
click
11
2017/07/18 18:04:15