Gp 11 Service Information; Gp 12 User Interface Tests Description - Xerox WorkCentre 4150 Service Manual

GP 11 Service Information

Purpose
To provide machine hardware and software information.
Procedure
1. Enter Diagnostics, GP 1.
2. Select the Service Information tab
3. The following options are displayed:
• Machine Serial Number.
• Images Since Last Call.
• Network IP Address.
• System Administration Passcode.
4. Choose from the following:
• HFSI.
• Software versions.
• Billing counters.
General Procedures and Information
GP 11, GP 12

GP 12 User Interface Tests Description

Purpose
To describe the user interface tests that are available in GP 4 System Administration Tools and
dC305.
Procedure
Refer to the relevant procedure:
• User Interface Button Test
• Audio Tone Test
• LED Indicator Test
• Touch Area Test
• Display Pixel Test
• Video Memory Test
• Reset User Interface
• Application Checksum Verification
User Interface Button Test
Use this test to verify that the buttons on the user interface are working correctly. After entering
this test, follow the instructions displayed on the user interface to perform, then exit the test.
Audio Tone Test
Use this test to verify that the audio tone on the user interface is working correctly. After enter-
ing this test, follow the instructions displayed on the user interface to perform, then exit the test.
LED Indicator Test
Use this test to verify that the LEDs on the user interface is working correctly. After entering this
test, follow the instructions displayed on the user interface to perform, then exit the test. Each
LED will flash on for approximately 1 second, then off sequentially in a clockwise direction.
Touch Area Test
Use this test to verify that the touch screen on the user interface is working correctly. After
entering this test, follow the instructions displayed on the user interface to perform, then exit
the test.
Display Pixel Test
Use this test to verify that the liquid crystal display module (LCDM) is working correctly. After
entering this test, follow the instructions displayed on the user interface to perform, then exit
the test.
Video Memory Test
Use this test to verify that the SRAM used by the video controller on the user interface is work-
ing correctly. After starting this test, each video SRAM location will be validated.
Reset User Interface
This procedure will reset the user interface.
September 2006
6-22 WorkCentre 4150