Connecting A Vcr; Connecting An S-Vhs Vcr - Samsung PL-42C71HP Owner's Instructions Manual

Connecting a VCR

These instructions assume that you have already connected your TV to an antenna or a cable TV system (according to the instructions on
pages 9-10). Skip step 1 if you have not yet connected to an antenna or a cable system.
VCR
5
2
4
3
➢
Each VCR has a different back panel configuration.
➢
When connecting a VCR, match the color of the connection terminal to the cable.
➢
The illustration for connecting jacks on the rear shown in this manual has been created based on
the PL-42C91HP model. Even though the jack configuration is different from your model, the
connection method is the same as in the illustration.

Connecting an S-VHS VCR

Your Samsung TV can be connected to an S-Video signal from an S-VHS VCR.
(This connection delivers a better picture as compared to a standard VHS VCR.)
VCR
3
2
1
An S-Video cable is usually included with an S-VHS VCR. (If not, check your local electronics store.)
➢
Each S-VHS VCR has a different back panel configuration.
➢
When connecting an S-VHS VCR, match the color of the connection terminal to the cable.
➢
Some games may be displayed with a cut off picture when the TV is connected to a game player.
➢
The illustration for connecting jacks on the rear shown in this manual has been created based on
the PL-42C91HP model. Even though the jack configuration is different from your model, the
connection method is the same as in the illustration.
Audio Cable (Not supplied)
Video Cable (Not supplied)
Antenna Cable (Not supplied)
TV Side Panel
Audio Cable (Not supplied)
S-Video Cable (Not supplied)
Antenna Cable (Not supplied)
TV Rear Panel
TV Rear Panel
English-11
1. Unplug the cable or antenna
from the back of the TV.
2. Connect the cable or antenna
to the ANT IN terminal on the
back of the VCR.
3. Connect an Antenna Cable
between the ANT OUT
terminal on the VCR and the
ANT IN terminal on the TV.
4. Connect a Video Cable
between the VIDEO OUT jack
on the VCR and the AV IN 1
[VIDEO] jack on the TV.
5. Connect Audio Cables
between the AUDIO OUT
jacks on the VCR and the
AV IN 1 [R-AUDIO-L] jacks
on the TV.
➢
If you have a "mono"
(non-stereo) VCR, use a
Y-connector (not supplied) to
hook up to the right and left
audio input jacks of the TV.
If your VCR is stereo, you
must connect two cables.
1. To begin, follow steps 1–3
in the previous section to
connect the antenna or
cable to your VCR and
your TV.
2. Connect an S-Video Cable
between the S-VIDEO OUT
jack on the VCR and the
AV IN 2 [S-VIDEO] jack on
the TV.
3. Connect Audio Cables
between the AUDIO OUT
jacks on the VCR and the
AV IN 2 [R-AUDIO-L] jacks
on the TV.