Advertisement
To mount a wedge camera to TVD-
PPB pendant mount with a TVD-CB2
cup base:
1.
Screw the pendant mounting plate
onto the pendant mount pipe and
tighten with the locking screw, as
shown.
2.
Pull the camera cables through the
pendant mount. Attach the mount
to the ceiling with expansion
anchors that are included with the
pendant mount.
3.
Using four screws that are included
with the wedge camera, attach the
wedge adapter plate to the cup
base. Screw the cup base onto the
pendant mount and tighten with the
locking screw.
4.
Loosen the screws on the wedge
bubble assembly using the Torx
P/N 1073418-EN • REV A • ISS 12FEB18
wrench that is supplied with the
camera, and remove the enclosure.
5.
Using two screws that are supplied
with the wedge camera, attach the
camera base to the wedge adapter
plate.
6.
Re-attach the camera enclosure to
the camera.
Legal and regulatory
information
Copyright
© 2018 United Technologies
Corporation. All rights reserved.
Interlogix is part of UTC Climate,
Controls & Security, a unit of United
Technologies Corporation.
Trademarks and
The trade names used in this
patents
document may be trademarks or
registered trademarks of the
manufacturers or vendors of the
respective products.
3 / 4
Advertisement
