Modes And Features - EdgeStar AP13500G Owner's Manual

Modes and Features

Auto
When selecting Auto Mode, the air conditioner will operate automatically according to the
ambient room temperature. The set temperature is not adjustable in AUTO mode. This is the
default mode of operation when the unit is powered on.
Cool
If the ambient temperature drops below the temperature you selected, the compressor turns off
and the unit functions with the fan only. When the temperature rises above the temperature
you selected, the compressor turns on again. The Cool Indicator will be lit. You can press the
"+" or "-" to increase or decrease the set temperature.
Note: The exhaust hose must be used in cooling mode in order to cool a room.
Note: Whether your desired temperature can actually be reached depends on the ambient
conditions. The room temperature remaining slightly above the set temperature is normal.
To operate the unit in cooling mode:
1. Make sure the power cord is plugged into a power outlet.
2. Press the ON / OFF button on the remote.
3. Press the Mode button until the Cool Indicator Light on the Control Panel lights up.
4. Select the fan speed by using the Fan button.
5. Set the thermostat by using the "+" and "-" buttons on the remote. The thermostat is
adjustable between 61°F and 86°F in one degree increments.
Dry
When dry mode (or dehumidify mode) is selected, the air conditioner operates under dry mode
at a low fan speed. The Dry Indicator light will be lit. Under dry mode the fan speed can't be
adjusted.
Fan
Fan Only mode is used to circulate the air in your room. No temperature setting is needed.
Note: Fan Only mode does not require that the exhaust hose be attached.
To operate the unit in Fan Only mode:
1. Make sure the power cord is plugged into a power outlet.
2. Press the ON / OFF button on the remote.
3. Press the Mode button until the Fan Indicator light on the control panel lights up.
4. Press the Fan button to adjust the fan speed.
Timer
Pressing the Timer will activate the Timer Mode settings. Pressing the "+" or "-" buttons will
adjust the timer setting in increments of ½ hour up to 10 hours and then in increments of 1
hour up to 24 hours while using the remote control. The display will remain in timer mode for
five (5) seconds and then revert back to displaying the temperature. Press the Timer button
again to cancel the timer mode.
20