Various Setting Methods; Placing On A Table And Projecting - Epson H928A User Manual

Preparing

Various Setting Methods

Warning
•
A special method of installation is required when suspending the projector from a ceiling (ceiling mount). If
it is not installed correctly, it could fall, causing an accident and injury.
•
If you use adhesives, lubricants, or oil on the ceiling mount fixing points to prevent screws from loosening,
or if you use items such as lubricants or oils on the projector, the outer projector case may crack, which causes
it to fall from its ceiling mount. This could cause serious injury to anyone under the projector and also damage
the projector.
•
Do not set up the projector in locations exposed to high humidity and dust, such as on a kitchen counter, in
the kitchen, or near a humidifier, or in locations exposed to oil smoke or steam. Doing so could cause fire or
electric shock. In addition, the oil content could cause the projector's outer case to deteriorate and could
cause the projector to fall off from the ceiling where it is suspended.
•
Do not install it on an unstable shelf or in a place out of load range. Otherwise, it could fall or topple causing
an accident and injury.
•
When installing it in a high position such as on a shelf, take measures against falling by using wires to ensure
the safety in an emergency, such as an earthquake, and prevent accidents. If it is not installed correctly, it
could fall causing an accident and injury.
•
Do not block the air intake vent and air exhaust vent of the projector. Blocking its air intake vent and air
exhaust vent may trap heat inside causing fire.
Attention
•
Do not use the projector installed vertically. Doing so could cause a malfunction.
•
Clean the air filter once every three months. Clean it more often if the environment is particularly dusty.
p.100
s

Placing on a table and projecting

You can install the projector on a table in your living room or on a low shelf to project images.
15