Setting-Up Methods - Epson EMP-TW100 Setup Manual

The projector supports the following five projection methods, allowing you to choose the
best method for displaying your images.
After setting up the projector, refer to the User's Guide for details on turning on the power
and adjusting settings such as the screen size. ( "Basic Operations" in User's Guide)
When setting up the projector, be sure to first read the Safety
Instructions/World-Wide Warranty Terms for information on the safety
precautions that must be observed at this time.
Front projection
Front/ceiling projection
* A special method of installation is required in order to suspend the projector from the ceiling. Please
contact the place of purchase if you would like to use this installation method.
* When installing to the ceiling or projecting from behind the screen, set the Screen Mode command in the
Settings environment setting menu to match the method of projection being used.
( " Settings " menu in User's Guide)
5

Setting-up Methods

Rear projection using a
translucent screen
Rubber stands
(Attach in
3 places)
Projecting from locations such as the
top of a cabinet
When installing the projector upside down, set
the Screen Mode command in the Settings
environment setting menu to "Front/Ceiling".
("Settings" menu in User's Guide)
Rear projection onto a
translucent screen with the
projector installed to the ceiling
When turning the projector upside
down, attach the rubber stands that
are included.
This can prevent the control panel
from directly touching the
installation surface.