Operation; Selecting The Video Signal-Source; Storing Channels In Memory (Automatic Method) - Samsung HP-P5091 Quick Setup Manual

Operation

Selecting the Video Signal-source

Before your television can begin memorizing the available channels, you must specify the
type of signal source that is connected to the WIRELESS HOME AV CENTER (i.e., an
antenna or a cable system).
TV Channel
Select Antenna : Air √
√
Auto Program
√
Add/Delete
Fine Tune √
Signal Strength √
Move Enter Return
TV Channel
Select Antenna : Air Air
Cable
Auto Program
Add/Delete
Fine Tune
Signal Strength
Move Enter Return
TV Channel
Select Antenna : Air Air
Cable
Auto Program
Add/Delete
Fine Tune
Signal Strength
Move Enter Return

Storing Channels in Memory (Automatic Method)

TV Channel
Select Antenna : Air √
Auto Program √
√
Add/Delete
√
Fine Tune
Signal Strength √
Move Enter Return
TV Channel
√
Select Antenna : Air
Auto Program √
Add/Delete √
√
Fine Tune
√
Signal Strength
Move Enter Return
TV Auto Program
Air
STD
HRC
IRC
Move Enter Return
Auto Program
It will take about several minutes.
Would you like to continue?
Start
Enter Return
Auto Program
Air Ch 23
Stop
Enter Return
1
Press the MENU button. Press the ▲ or ▼ button to select "Channel", then press
the ENTER button.
2
Press the ▲ or ▼ button to select "Select Antenna", then press the ENTER button.
3
Press the ▲ or ▼ button to select "Air" or "Cable", then press the ENTER button.
4
Press the MENU button to exit.
1
First, select the correct antenna (Air and Cable). See steps on previous page.
Press the MENU button. Press the ▲ or ▼ button to select "Channel", then press
the ENTER button.
2
Press the ▲ or ▼ button to select "Auto Program", then press the ENTER button.
➤ Quick way to access the Automatic Channel Setting:
➤
Just press the "AUTO PROG." button on the remote control.
3
Press the ▲ or ▼ button to select the correct signal (Air, STD, HRC, and IRC).
Select an option and then press the Enter button.
If you are connected to an antenna (Air), leave "Air" displayed. If you are connected to a
cable, press the ▲ or ▼ button to display the type of cable system "STD", "HRC" or "IRC".
(If you are not sure which type of cable system you have, contact your cable company).
4
Press the ENTER button. The PDP will begin memorizing all of the available
channels. After all the available channels are stored, the Auto program menu
reappears. Press the MENU button to stop.
Note
Auto Program may take a few minutes to process.
●
8