Bernina Bernette Funlock b44 Instruction Manual page 25

2
2
3
3
3
3
3
3
6
6
7
6
7
8
7
9
8
9
7
7
7
2
2
5
4
5
4
5
4
8
9
8
9
8
8
9
9
– Thread the top cover thread guide by pulling the
thread towards the left until it slips under guide
(2)
. Then pull thread along the right side of
button as illustrated.
– While holding thread with fingers, pass it
between the tension discs and pull thread down
to make certain it is properly located in between
(3)
the tension discs
– Continue to thread points
PLEASE NOTE:
Slip thread into the rear slot on the thread guide
(5)
and bottom slot of take–up lever cover
Then slip thread into the left slot on the thread
(7)
guide , and into the left slot on the thread
(8)
guide .
Before threading eye of needle, slip thread behind
thread guide located on the bottom of the needle
clamp.
– Thread the eye of the left needle
PLEASE NOTE:
Use of tweezers in the accessory case will make
needle eye threading easy.
– The position of the thread must be behind the
thread guide.
– Draw about 4" (10 cm) of thread through needle
eye towards the rear of machine.
– Place the thread to the back, under the presser
foot.
.
(4) 9)
–( .
(6)
.
(9)
.
25