Replacing The Pro 550 Plus Handheld Device Battery - Garmin PRO 550 PLUS Owner's Manual

Security screws
Back plate
Battery
Battery connector
Front plate
Gasket
Replacing the Pro 550 Plus
Handheld Device Battery
Before you replace the battery, you must
remove all dirt, water, and debris from the
device. You also need a small Phillips
screwdriver and the security screwdriv r
included with the battery replacement ki
1
Remove the eight security screws from
the back of the device
2
Lift up the back plate.
3
Grip the battery conn ctor wires close
to the connector, and pu the
connector perpendicular t the circuit
board to disconn ct the battery
connector from the
4
Grip the rotary switch connector wires
close to the connector, and pull the
connector perpendicular to the circuit
board to disconnect the rotary switch
connector from the device.
Appendix
5
6
7
8
9
10
11
vice.
12
Remove the two screws from the
battery plate.
Lift up the battery plate.
Remove the old battery from the back
plate, noting the orientation of the
battery.
The battery fits tightly. It may be
nec ssa y to pry the battery out of the
back plate sing a non-sharp, non-
metal object.
Ins all the new battery into the back
late with the label side up, using the
same orientation as the old battery.
The battery orientation is noted
graphically inside the back plate.
Replace the battery plate to its original
position.
Replace and tighten the battery plate
screws.
With the new battery, connect the
battery connector to the device.
When properly installed, the connector
plug snaps into the port.
Reconnect the rotary switch connector
to the device.
15