Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Garmin TT 25
Summary of Contents for Garmin TT 25
- Page 1 25 DOG COLLAR DEVICE ™ Owner’s Manual...
- Page 2 © 2023 Garmin Ltd. or its subsidiaries All rights reserved. Under the copyright laws, this manual may not be copied, in whole or in part, without the written consent of Garmin. Garmin reserves the right to change or improve its products and to make changes in the content of this manual without obligation to notify any person or organization of such changes or improvements. Go to www.garmin.com...
-
Page 3: Table Of Contents
Getting the Owner's Manual....6 Product Updates........7 Setting Up Wi‑Fi® for the Dog Collar Device........7 Setting Up Garmin Express....7 Connecting the Dog Collar Device to a Computer..........7 VHF Radio Information......7 Dog Collar Device Specifications... 8 Appendix.......... -
Page 5: Getting Started
Getting Started WARNING See the Important Safety and Product Information guide in the product box for product warnings and other important information. Dog Collar Device VHF antenna GPS antenna Power button Contact points Status LED Flashing beacon LEDs Turning On the Device •... -
Page 6: Charging The Dog Collar Device
Charging the Dog Collar Device NOTICE To prevent corrosion, thoroughly dry the contacts on the dog collar device and the surrounding area before connecting the charging clip. You should fully charge the battery before you use the dog collar device for the first time. Charging a fully depleted battery takes about five hours. -
Page 7: Selecting And Installing The Contact Points
Selecting and Installing the Contact Points CAUTION To prevent irritation from the contact points, remove the collar for at least eight hours out of every 24-hour period. Do not spray the device or collar with harsh chemicals including but not limited to flea or tick spray. Always ensure that any flea or tick spray that is applied to the dog is completely dry before placing the collar on the dog. -
Page 8: Dog Tracking And Training
3 Tighten the strap so that it is snug around the dog's neck, and fasten the buckle. NOTE: The collar should fit tightly and should not be able to rotate or slide on the dog's neck. The dog must be able to swallow food and water normally. You should observe your dog's behavior to verify that the collar is not too tight. -
Page 9: Collar Training
Collar Training Begin training your dog on a leash, without using the Alpha training system. After the dog shows a grasp of the commands "heel," "sit," and "here," you can begin training with the collar and the leash. During the initial stage of collar introduction, the dog learns that collar stimulation means the same thing as a tug on the leash. -
Page 10: Communication With The Dog Collar Device
• Select Wake to exit sleep mode. Device Information Getting the Owner's Manual You can get the latest owner's manual from the web. 1 Go to www.garmin.com/support. 2 Select Manuals. 3 Follow the on-screen instructions to select your product. Device Information... -
Page 11: Product Updates
Product Updates On your computer, install Garmin Express (www.garmin.com/express). ™ This provides easy access to these services for Garmin devices: ® • Software updates • Product registration Setting Up Wi‑Fi for the Dog Collar Device ® When paired with a navigator that supports the setup of Wi‑Fi technology on a dog collar device, the dog collar device can scan for nearby Wi‑Fi networks and pair to a selected network. -
Page 12: Dog Collar Device Specifications
• Optional accessories are available at garmin.com or from your Garmin dealer. Only for use with Garmin part number 361-00035-16. Only for use with Garmin part number 361-00148-00. The device withstands pressure equivalent to a depth of 10 m. For more information, go to www.garmin.com/waterrating. Appendix... -
Page 13: Replacing The Dog Collar Battery
Replacing the Dog Collar Battery Before you replace the battery, you must remove all dirt, water, and debris from the dog collar device. You must also have a small Phillips (#2) screwdriver and a small TORX (T5) screwdriver. ® 1 Remove the 2 screws from the cover over the VHF antenna. -
Page 14: Replacing The Dog Collar Flex Band
Replacing the Dog Collar Flex Band Before you replace the dog collar flex band, you must remove all dirt, water, and debris from the dog collar device. You must also have a small Phillips (#2) screwdriver. 1 Remove the 2 screws securing the dog collar flex band to the back plate. -
Page 15: Replacing The Dog Collar Vhf Antenna
Replacing the Dog Collar VHF Antenna Before you replace the VHF antenna, you must remove all dirt, water, and debris from the dog collar device. You must also have a small Phillips (#2) screwdriver. 1 Remove the 2 screws from the cover over the VHF antenna. 2 Remove the VHF antenna cover. - Page 16 May 2023 GUID-992E9C90-AE40-4ED4-B3C4-9D812BD4DF89 v1...