Connecting To A Power Source; Rechargeable Battery Specification - Samsung SL600 User Manual

Connecting to a Power Source

You should use the rechargeable battery BP70A supplied with the
camera. Be sure to charge the battery before using the camera.
Ê BP70A rechargeable battery Specification
Model BP70A
Type Lithium lon
Capacity 740mAh
Voltage 3.7V
Charging time Approximately 150 Minutes
Ê Number of images and battery life: Using the BP70A
Battery life /
Number of images
Approx. 125 MIN /
Still image
Approx. 250 shots
Movie Approx. 110 MIN
Ä These figures are measured under Samsung's standard conditions
and shooting conditions and may vary depending on the user's
methods.
012
Conditions
Using the fully charged battery, Default
settings, Program mode, Shot to shot
interval: 30Sec.
Changing the zoom position between
the Wide and the Tele after every shot.
Using the flash on every second shot.
Using the camera for 5 minutes and
then powering it off for 1 minute.
Using the fully charged battery
640x480 image size
30fps frame rate
Important information about battery usage.
å When camera is not in use, turn off the power.
å Please remove the battery if the camera will not be used
for long periods. Batteries can lose power over time and are
prone to leaking if kept inside the camera.
å Low temperatures (below 0°C) can affect the performance of
the battery and you may experience reduced battery life.
å Batteries will usually recover at normal temperatures.
å During extended use of the camera, the camera body may
become warm. This is perfectly normal.
Ê Connecting the AC adapter with the USB cable can be used as an
AC cable, and you can charge the rechargeable battery with the
AC cable.
- Using an AC cable
: Connect the AC adapter to the USB
cable. It can be used as a power
cable.
- Using a USB cable
: Remove the AC adapter.
You can download stored images
to your PC (p.89) or supply the
power to your camera through the
USB cable.