Yaesu FT-1000MP Operating Manual page 93

Menu Programming
-
Selection & Settings
i t
-
8- 4
I : I
~ c - F U I - ~ C
Remote Controi Function- Selects the active
feature for remote control operation. Note - Re-
mote control operation requires constructing a
12-switch input keyboard for operation, see the
description and charts on pages 60-63 for details
of operation.
Keyer
-
Activates contest keyer operation.
Function Keys
-
Emulates front panel Memory
Control keys.
VFO-A
-
Enables direct-frequency input to
VFO-A by emulating the front panel keypad keys.
VFO-B
-
Enables direct-frequency input to
VFO-B by emulating the front panel keypad keys.
o.n
F 8 5 t - i i 8
U
LI
3 C C
FAST Button Operation
-
Select front-panel
FAST
button actuation:
Momentary - press and hold to engage fast
tuning.
Continuous - toggle onltoggle off fast tuning.
8.. 1
i L I C t
- F "
2 L
L
LOCK Button Operation - Choose between
Dial
-
locks MAlN VFO-A knob only
Panel - locks front panel buttons & keys (refer
to drawing below).
Primary
-
locks front panel primary function
keys (refer to drawing below).
Panel Lock
-
when the Main VFO (A) lock is pressed, all
controls within the shaded area are disabled.
When the Sub VFO (B) lock is pressed, only the SUB VFO
tuning knob is disabled.
Primary Lock - when the Main VFO (A) lock is pressed, only
the MAlN VFO tuning knob is disabled.
When the Sub VFO (B) lock is pressed, all controls within
the shaded areas are d~sabled.
Split Mode Operation - Selects one of three
split operating modes:
Normal - in this default mode, pressing
activates SUB VFO-B for transmission. Other set-
tings (such as mode and frequency) must be
manually set for the Sub VFO.
Auto - when
i s PLnl
is pressed, SUB VFO-B is
enabled for transmit, and the selected operating
mode from MAlN VFO-A is automatically copied
into SUB VFO-B.
A=B - Same as Auto mode above, however, a
preset frequency offset is applied to SUB VFO-B
for transmission.
Receiver Front-End RF Amplifier - Select the
desired receiver front-end amplifier configuration:
Flat - A broadband amplifier with flat response
Tuned - A separate tuned amplifier for low and
high bands.
Antenna Selection
-
Choose between:
AUTO
-
Antenna selections are automatically
copied along with other operating parameters
during memory programming.
ON - Enables front panel
ANT
switch.
OFF- Disables the front panel
ANT
switch (only
ANT-A is selected).
User Setting
-
This configures an operating
"environment" selected by pressing the front-
panel
USER
button. Operating parameters are se-
lected using the SUB VFO-B knob, while options
are chosen with the MAlN VFO-A knob.
Mode
-
This selects to which mode the custom
settings are applied. Choose LSB, USB, CW (nor-
mallreverse), RTTY (normallreverse), or packet
(LSB only).
Display Offset - You can choose a custom
offset f5.000 kHz (in 5-Hz steps) to take effect
when the User mode is active. The default offset
is dependent upon operating mode.
Rx PLL Offset - You can offset the receiver PLL
frequency f5.000 kHz (in 5-Hz steps) when the
USER
button is pressed.
page 91