Tuning Knob Torque Adjustment - Yaesu FT-1000MP Operating Manual

Installing Internal Accessories
Toning Knob Torque Adjustment
O Turn the exposed shaft tension spring counter-
clockwise to loosen the torque, or clockvvise to
If the tuning knob is too tight or too loose for
tiahten.
your preference, and if you have a 2-mm
( ' / i 4 " )
Allen wrench, you can adjust the torque.
O Pull the knurled rubber ring off of the tuning
knob.
O Locate the hole in the edge of the tuning knob,
and use the Allen wrench to loosen the set
screw accessible through the hole, just enough
to allow the knob to be pulled off the shaft.
O Replace the knob, tighten the set screw, and
replace the rubber ring.
7
Power-on Settings
I
Some or all transceiver settings can be reset to their factory-default states using one of the following power-on routines:
I
I
m+
POWER
Resets all menu setting to factory-default.
I
I
I /
m+m
+POWER
Resets all memories (except menu settings) to factory-default.
I
I
/
POWER
1
CPU master reset for all memories and menu settings
page 102