Advertisement
Multi-display 10-Channel and 16-Channel Timers
755-HM10 and 755-HM16
Timer Programming
To program the timer, all 10 or 16 timing channels must be idle with
the display showing either one or three sets of four dashes and all
LED's turned off. A single set of dashes is shown to program Menu
1 and three sets of dashes are shown to program Menu 2.
1
2
3
4
Entering Program Mode
Press and hold the Prince Castle logo button for 6-8 seconds to
enter the Programming Mode. The display changes to "Prog" and all
channel LED's turn red.
1
2
3
4
Printed in USA 3/06 © 2006
5
9
6
10
7
11
8
12
5
9
6
10
7
11
8
12
Programming
Countdown Mode
NOTE: This mode can only be entered when all channels are idle.
Enter the Countdown Mode by holding the UP button for 6 seconds.
This will determine if all the timing cycles count up from 0:00 or
count down to 0:00. Use the UP or DOWN buttons to toggle between
count up or count down. Display 1 will indictor "C-uP" or "C-dn".
When the desired mode is obtained, momentarily press any channel
button to save it and return to Timing Mode.
NOTE: To return to Timing Mode without saving, momentarily press
the Prince Castle logo button.
13
14
15
16
1
2
3
4
13
14
15
16
4
5
9
6
10
7
11
8
12
755-503revA
13
14
15
16
Advertisement
