Table of Contents
Advertisement
Page 100 of 174
553-3001-216 Standard
Installation
To remove the HookSwitch cover:
1
Ease the cover to the left and pull on the left side to release the left
snap.
2
While holding the left snap out, ease the cover to the right and pull on
the right side to release the right snap.
3
Carefully maneuver the cover out from the three bottom slots and
rotate the cover to release the two side tabs.
Figure 17
Installation of the cradle
To install the cradle:
1
Hold the cradle in the same position as when you removed the Hook
Switch Cover; move the cradle to the right to place the tab into the slot.
2
Ease the other tabs on the bottom edge of the cradle into the slots.
3
When all tabs are in the proper position, secure the cradle into place
by pushing straight downward.
5.00
January 2002
553-9048
Advertisement
Table of Contents
