Samsung SyncMaster 400CX-2 Quick Start Manual page 33
Samsung lcd display quick start guide
Hide thumbs
Also See for SyncMaster 400CX-2:
- User manual (151 pages) ,
- Quick start manual (25 pages) ,
- Quick start manual (25 pages)
Table of Contents
Advertisement
PC Mode
Q:
The LCD Display screen flickers.
A:
Check if the signal cable between the computer and the LCD Display is securely
connected.
(Refer to Connecting a Computer )
TV Mode
Q:
TV screen is blurred or shows noise signals.
A:
Check if the TV antenna connector is securely connected to the external antenna.
(Refer to Connecting TV)
Problems related to the Screen
Note
Problems related to the LCD Display screen and their solutions are listed.
Q:
The screen is blank and the power indicator is off.
A:
Ensure that the power cord is firmly connected and the LCD Display is on.
(Refer to the Connecting a Computer )
Q:
"Check Signal Cable " message.
A:
Ensure that the signal cable is firmly connected to the PC or video sources.
(Refer to the Connecting a Computer )
A:
Ensure that the PC or video sources are turned on.
Q:
"Not Optimum Mode " message.
A:
Check the maximum resolution and the frequency of the video Adaptor.
A:
Compare these values with the data in the Preset Timing Modes Chart.
Q:
The picture rolls vertically.
A:
Check if the signal cable is securely connected. Re-connect it, if necessary.
(Refer to Connecting a Computer )
Q:
The image is not clear; picture is blurred.
A:
Run Frequency Coarse and Fine tuning.
A:
Turn on again after removing all accessories (video extension cable, etc.)
A:
Set the resolution and frequency to the recommended ranges.
Q:
The picture image is unstable and shakes.
A:
Check if the resolution and frequency set for the computer video card falls in the
range supported by the LCD Display. If not, reset them referring to the current
Information under the LCD Display menu and Preset Timing Modes.
Troubleshooting
109
Advertisement
Table of Contents
