Earth Rail And Tagging Accessories - Eaton MTL5501-SR Instruction Manual

4 .3
This section explains how to specify and assemble earth rail and tagging strip accessories for the
MTL5500 range.
The accessories consist of mounting brackets, earth rails, tagging strips and associated parts. They
provide facilities for earthing, terminating cable screens and tagging (identifying) the positions of
individual units.
4 .3 .1
IMB57
One required at each end of a tagging strip/earth rail. Suitable for low-profile (7 .5mm) and high-
profile (15mm) symmetrical DIN rail.
ERB57S
Nickel-plated bus bar; supplied with two push fasteners, one earth-rail clamp (14mm, 35mm
one earth cable clamp (10mm, 16mm
Note: ERB57S is the preferred choice of earth-rail bracket. It is usually fitted in the upper slot on
insulating mounting block IMB57.
Where the earth rail is required to be positioned at a lower height and to allow access to the IMB57
mounting screws, the straight earth-rail bracket ERB57S can be inserted in the lower slot, but only
after insulating mounting blocks IMB57 are clamped to the DIN rail. This may not be possible if, for
example, trunking is fitted. In this case, fit offset earth-rail bracket ERB570 (see figure 4.4 & 4.10) in
the upper slot: the mounting blocks can then be fitted in a restricted space with this bracket already
fitted.
ERB570
Nickel-plated bus bar; supplied with two push fasteners, one earth-rail clamp (14mm, 35mm
one earth cable clamp (10mm, 16mm
ERL7
Nickel-plated bus bar; may be cut to length.
TAG57
Cut to size. Supplied with tagging strip label.
TGL57
Spares replacement, for use with TAG57 tagging strip.
MS010
Grey spacer; Used to provide 10mm air-circulation space between modules, if necessary.
ETM7
For terminating cable screens and 0V returns on the ERL7 earth rail. For cables ≥ 4mm
TH5000
Spares replacement.
Connectors (Figure 4 .5)
Spares replacement: HAZ1-3, HAZ4-6, HAZ-CJC, PWR5000, SAF7-9, SAF10-12 (SAF1-3 and SAF4-6
grey connectors, also available for use in safe-area applications).
4 .3 .2
4 .3 .2 .1
a) In upper position
Before fitting insulating mounting blocks IMB57 , check that the swing nuts in the base of
each unit are turned back into the moulding. Locate the mounting blocks on the DIN rail in the
chosen position and tighten the screws (see figure 4.10). Check that the swing nuts rotate
correctly to locate underneath the flanges of the DIN rail.
8

Earth rail and tagging accessories

Parts list
Insulating mounting block (Figures 4 .3, 4 .4 & 4 .5)
Earth-rail bracket, straight (figure 4 .3, 4 .4 & 4 .9)
2
).
Earth-rail bracket, offset (figure 4 .9)
Earth rail, 1m length (figure 4 .9)
Tagging strip, 1m length (figure 4 .3, 4 .4 & 4 .6)
Tagging strip labels, set of 10 x 0 .5m (figure 4 .3 & 4 .4)
DIN rail module spacer, 10mm, pack of 5 (figure 4 .7)
Earth terminal, bag of 50 (figure 4 .8)
Tag holder
Assembly
Fitting earth rails
2
).
2
) and
2
) and
2
.
INM 5500 Rev 10