Chamberlain CSL24UL Installation Manual page 53

Miscellaneous
Post-mounting plate
For post-mounting models CSL24UL,
CSW24UL CSW200UL and SL3000UL
commercial gate operators. Posts not
included.
Model MPEL
Remote antenna extension kit
The remote antenna extension kit allows the
antenna to be remotely installed.
Model 86LM
Plug-in loop detector
Low power. Conveniently plugs into
existing control board.
Model LOOPDETLM
Loop Detector
Low power loop detectors mounted and
wired separately inside control box.
LiftMaster low power accessory.
Model LD7LP
Vehicle sensing probe
The vehicle sensing probe is buried in the
ground and can detect a car as it
approaches and will then open the gate.
Model CP3
Solar panel kit
This kit is to replace or add a solar panel to
the operator application. 60W maximum for
24 Vdc operators and 30W maximum for
12 Vdc operators. Requires a 33AH battery
harness.
Models SP10W12V (10 Watt, 12V) and
SP20W12V (20 Watt, 12V)
Magnetic gate lock
Outdoor magnetic lock, transformer,
junction box, mounting plate and hardware.
Not for use with Solar Applications. Must
be powered separately.
Model MG1300
Heater
The heater keeps the gearbox and batteries
at a suitable temperature when the outside
temperature is below -4°F (-20°C). The
thermostat MUST be set between 45°F and
60°F (7°C and 15.5°C) to ensure proper
gate operation. The heater can be powered
by 110 to 250 Vac.
Model HTR
ACCESSORIES
Solenoid lock harness kit
Model K77-37972
Batteries
Gate access system batteries replace or upgrade the gate operator batteries.
Two identical 12 Vdc batteries are required for each gate operator. Do not
mix 7AH and 33AH batteries within a gate operator.
53
®
LiftMaster internet gateway
Internet enabled accessory which connects to the
computer and allows you to monitor and control
gate operators and lighting accessories enabled by
®
MyQ technology.
Model 828LM
LiftMaster Cloud™ connected access protocol -
high capacity
Model CAPXL
Warning sign
Model 40-39235
Transformer kit
Changes input voltage (208/240/480/575 Vac) to an
output voltage of 120 Vac. Rated 208/240/480/575
Vac, 4.8/4.2/2.1/1.7 A, 60 Hz, 1 PH
Model 3PHCONV
7AH batteries
Standard 7 AMP-Hour Battery, 12 Vdc, to replace
original batteries provided with operator. Reuse
existing harnesses.
Models 29-NP712 (1) and K74-30762 (2)
33AH batteries
Upgrade 33 AMP-Hour Battery, 12 Vdc. Ideal for
solar applications and extended battery backup. Two
required.
Model A12330SGLPK
Battery tray
Two required for 33AH applications.
Model K10-34758-2
Universal solar wire harness kit
For 7AH and 33AH applications.
Model K94-37236