Vlbck48 Corner Kit - Marquis MQVL48LP Installation Instructions Manual

VLBCK48 Corner Kit for MQVLB48 Peninsula Bay
MUST BE INSTALLED BEFORE UNIT IS INSTALLED INTO FRAMING.
⚠
Warning: Failure to position the parts in accordance with these diagrams or failure to use only parts specifically
approved with this appliance may result in property damage or personal injury.
Contents of Kit:
 Firebox Cover with Gasket - 1
 Heat Shield with Standoff- 2
 Inner Liner Panel - 3
 Front Side Cover - 4
 90ml Tube Millpac
 [Qty 22] 1/2" DT Screws
 [Qty 6] Pan Head Screws
Procedure:
Remove Lower Front
1.
Panel Assembly.
Remove Side Glass
Panel from firebox
(Refer to Glass Door
Installation and
Removal). This side
glass will not be
reused.
Remove Outer
2.
Glass Supports
from side of fireplace.
These will not be
reused.
Apply a small bead of
3.
Millpac to Firebox
Cover Gasket. Insert
Firebox Cover into
place from front of
DO NOT
fireplace.
STRIP
SCREWS.
Using the 2
4.
Location Starter
Holes in Front Post
of fireplace to
position Firebox
Cover, Fasten to
firebox using 1/2" DT
Hex Screws.
IF USING
5.
PORCELAIN OR
FLUTED LINERS:
For Back Corner,
[Qty 4] 1/8" pilot
holes can be drilled,
or screws must be
removed and
CONTINUED ON NEXT PAGE
CORNER KIT CAN BE INSTALLED AT EITHER END OF FIREPLACE.
SHEET METAL COMPONENTS:
1
Firebox Cover
Remove Lower
Front Panel
Assembly
Firebox
Cover
Lower Front
Panel Assembly
must be removed
2
Heat Shield Inner Liner Panel
Remove Outer
Glass Supports
1
Apply Millpac
to gasket
Option
3
Remove Side
Glass from
firebox.
Heat Shield
Stand-off
4
2
28