Onkyo TX-RZ830 Instruction Manual page 100

Switch remote control mode (ZONE 3)
Setting the ZONE
control mode (ZONE 3)
Setting the main room
control mode
Contents Connections
≫
At the time of purchase, the remote controller is in the mode to control playback
in the main room. Settings are required to playback a source in ZONE 3.
When outputting from the speakers:
Speaker" in the Setup menu (
controller to ZONE control mode (ZONE 3). To operate the playback of the main
room again, it is necessary to return the remote controller to the main room
control mode.
When outputting from the integrated amplifier or the power amplifier:
"2. Speaker" - "Configuration" in the Setup (
and set the remote controller to ZONE control mode (ZONE 3). To operate the
playback of the main room again, it is necessary to return the remote controller to
the main room control mode.
– Set "Speaker Channels" to "2.1 ch", "3.1 ch", "4.1 ch", or "5.1 ch"
– Set "Speaker Channels" to "2.1.2 ch", "3.1.2 ch", "4.1.2 ch", or "5.1.2 ch", and
set "Bi-Amp" and "Zone Speaker" to "No"
1. While pressing and holding MODE, press ZONE 3 at least 3 seconds until the
remote indicator blinks three times.
• The mode of the remote controller switches to the mode to control ZONE 3.
• To restore the main room control mode, while pressing and holding MODE,
press MAIN at least 3 seconds until the remote indicator blinks once.
Setting the ZONE control mode
(ZONE 3)
ZONE 3
100
Front Panel≫ Rear Panel≫ Remote≫
Playback
≫ ≫
Set "2. Speaker" - "Configuration" - "Zone
p132) to "Zone 2/Zone 3", and set the remote
p132) to one of the following,
Setting the main room control mode
MAIN
MODE
Setup
≫
Set
MODE