Advertisement
Step B: Attach Water Bottle Cage
Assembly hardware required: aty. (2)
Pan Head Screw (item #8)
1. Remove machine screws from computer mast.
2. Attach water bottle cage to bomputer mast using supplied screws.
Step C: Attach Computer Unit
Assembly hardware required: aty. (1)
COMPUTER WSCREWS (item #1)
1. Remove 4 screws from the back of the computer unit.
2. Connect HR sensor cable (see appendix picture C)
3. Connect the ribbon cable and sensor cable to the corresponding
connectors located on the back of the
unit. CAUTION: Be sure to orient tabs on ribbon cable with slots on receptacle (see appendix picture
D).
4. Set computer onto Computer Bracket. Align holes and hand-thread first screw- DO NOT TIGHTEN.
Hand-tighten remaining 3 screws. Tighten all screws - DO NOT OVERTIGHTEN.
5. Open the battery compartment and insert the included (4) C batteries into the COMPUTER (#1).
(Refer to your Schwinn SRB-1500 Owner's Manual for computer set up instructions)
Step D: Attach Stabilizer Adjustment
Assembly hardware required: Aty. (2) Stabilizer Bolts (item #16)
aty. (2) Gurved Washer (item #18)
1. Place the stabilizer tube (#5) under the rear frame (#3) aligning the holes.
2. Install stabilizer bolts (#16) through curved washer (#18) and secure to the stabilizer tube.
Step E: Seat Adjustment
For best results, the seat should be adjusted for your height.
1. Unlock "seat locking" mechanism.
2. Adjust seat location so that with feet on the pedals, you can comfortably reach pedal at full extension.
That's it! You're finished and now you can begin to reach your fitness goals!
Please reference the Owner's Manual for information regarding computer operation, product maintenance
Warranty information, and general fitness and exercise guidelines.
Schwinn Customer Service
1.877.417.0519
Advertisement
