Table of Contents
Advertisement
PROBLEM
Oven not clean after
The oven controls were not set
a self-cleaning cycle
correctly.
The oven was heavily soiled.
Steam from the vent When using the convection
feature, it is normal to see steam
coming out of the oven vent.
As the number of racks or amount
of food being cooked increases,
the amount of visible steam will
increase.
Burning or oily odor
This is normal in a new oven and
emitting from the
will disappear in time.
vent
Strong odor
An odor from the insulation around
the inside of the oven is normal
for the first few times the oven is
used.
Fan noise
A convection fan may automatically
turn on and off.
Oven racks are
The shiny, silver-colored racks
difficult to slide.
were cleaned in a self-cleaning
cycle.
Display goes blank.
A fuse in your home may be blown
or the circuit breaker tripped.
Display flashes.
There was a power failure.
Drawer does not
The drawer is out of alignment.
slide smoothly or
drags.
The drawer is over-loaded or the
load is unbalanced.
Warming drawer will
A fuse in your home may be blown
not work.
or the circuit breaker tripped.
The controls are not set correctly.
Excessive
There is liquid present in the
condensation in the
drawer.
drawer
Uncovered foods.
The temperature is set too high.
Food dries out in
Moisture is escaping.
the warming drawer.
The drawer is not fully closed.
POSSIBLE CAUSE
SOLUTION
•
See the section on self-cleaning on page
38.
•
Wipe up heavy spillovers before starting
the self-cleaning cycle. Heavily soiled
ovens may need to self-clean again or for
a longer period of time.
•
This is normal.
•
To speed the process, set a self-cleaning
cycle for a minimum of 3 hours.
•
See the section on self-cleaning on page
38.
•
This is temporary.
•
This is normal.
•
Apply a small amount of vegetable oil to
a paper towel and wipe the edges of the
oven racks with the paper towel.
•
Replace the fuse or reset the circuit
breaker.
•
Reset the clock.
•
Fully extend the drawer and push it all the
way in. See the page 46.
•
Reduce weight. Redistribute drawer
contents.
•
Replace the fuse or reset the circuit
breaker.
•
See the chapter on using the warming
drawer on page 16.
•
Remove the liquid.
•
Cover food with a lid or aluminum foil.
•
Adjust the temperature to a lower setting.
•
Cover food with a lid or aluminum foil.
•
Push the drawer in until the latch engages.
Troubleshooting _1
Hide quick links:
Advertisement
Table of Contents
