Table of Contents
Advertisement
The RS-10 Receiver/Speed Module
1. Receiver & ESC:
(Electric Speed Control)
2. Crystal:
3. Power Switch:
4. Antenna Holder/Tube: Mounts the antenna tube as a transmitter's link.
5. Power Harness Plug: Connects the battery pack to the unit.
6. Steering Servo Plug: Connects the steering servo to the unit.
7. Motor Plug:
8.Steering Servo:
The RS-10 Receiver/Speed Module
vehicle. Each band has 6 different frequencies available allowing users to change the crystals for
versatile operating at the same time. When changing the crystal, just replace a set of crystal plugging on
transmitter and on receiver simultaneously by pulling it out. Then push a new set of crystal into the
socket carefully on the RS module and Transmitter respectively. (Caution: do not bend the two pins of the
crystal or it would cause damage of your model.) The following frequencies are available.
27MHz
Frequency List
* 26.995 MH Brown Flag
* 27.0295 MH Orange Flag
* 27.195 MH Green Flag
Each frequency is assigned a colored flag. Attach this flag to the end of your transmitter antenna so that
other modelers can determine your frequency from a distance. This is very important since it is not
possible for more than one model to operate on the same frequency at the same time.
6
Receives the signal from the transmitter to control your vehicle and control the
power input and rotating direction of the motor.
To change the channel it receives
Sliding to turn the unit on or off.
Connects the motor to the unit to get power supply.
ACE Micro Servo C1016 provides enough to push/pull the steering servo saver.
* 27.045 MH Red Flag
* 27.145 MH Yellow Flag
* 27.225 MH Blue Flag
2
1
5
uses 27mhz band to operate your
3
4
5
3
Advertisement
Table of Contents
