Intermediate Calibration; Dealer Calibration - Raymarine ST40 Depth Instrument Owner's Handbook Manual

26

4.3 Intermediate calibration

Intermediate calibration enables you to:
• Check the instrument software version.
• Set the instrument status - either MASTR (master) or
Follow the procedure in the Intermediate calibration flow diagram.

4.4 Dealer calibration

Dealer calibration enables you to set:
• User calibration on/off.
• Boat show mode on/off.
Dealer calibration also gives access to the Factory defaults screen.
This enables you to re-apply the factory settings if you want to reset the
instrument to a known operating condition.
Follow the procedure in the Dealer calibration flow diagram.
REPTR (repeater).
INTERMEDIATE CALIBRATION
During normal operation
hold down
Software
version
Instrument
status
To save your settings andreturn to normal operation from either screen,
hold down
ST40 Depth Instrument Owner's Handbook
and
for approximately 4 seconds
Note:
If there is no key activity when
the Software version screen
is displayed, calibration will
time out to normal operation
after 5 seconds,
CAL
and for approximately 2 seconds
D4663-2