Ending Dockside Setup; Seatrial Calibration; Warning: Ensure You Have Sufficient Sea Room For Calibration17 - Raymarine ST70 User's Reference Manual

Chapter 2: Commissioning Procedures
ENTER
5. Press
for the data you have selected.
<
6. Use or
value gives a quicker response rate and vice
versa.
ENTER
7. Press
the Response menu.
8. If you want to change the response for other
data types, use
data type, then repeat steps 5 to 8.
9. To leave response setup, ensure the Response menu is displayed, then:
i. Press
ii. Press
iii. Press

Ending dockside setup

Dockside setup is complete when you have satisfactorily carried out the initial setup
procedures and correctly set the:
• Depth offset.
• Water temperature.
• Magnetic variation.
• Ground wind calculation method.
• Response rate.
When Dockside setup is complete, return to the operational page, then carry out a

Seatrial calibration.

2.2 Seatrial calibration
WARNING: Ensure you have sufficient sea room for calibration
The seatrial calibration maneuvers require a sufficiently clear area of
water. Ensure you are not likely to collide with any vessel or obstruction
during calibration.
When the dockside calibration procedures are complete, navigate to a place where
you have plenty of sea room then carry out the seatrial calibration procedures. These
set the ST70 instrument so it gives an optimum performance with the system
transducers. The seatrial calibration comprises:
• Wind calibration & alignment.
• Speed calibration.
When you have completed the appropriate seatrial procedures, proceed to Return to
normal operation.
to display the response adjust box
>
to set the response rate. A higher
to save the value and return to
< >
or to scroll to the required
CANCEL
to return to the Display Settings menu.
CANCEL
to return to the Main Menu.
CANCEL
to return to the operational page.
Speed
12
< & > adjust response level.
i
CANCEL exits without saving
Press ENTER to accept
17