Cisco Aironet LAP1522 Hardware Installation Manual page 48

Mounting the Access Point
To mount the access point on a vertical wall, follow these instructions:
Use the mounting bracket as a template to mark four screw hole locations on your mounting surface. See
Step 1
Figure 2-6
mounting holes or the mounting slots.
Caution The mounting surface, attaching screws, and optional wall anchors must be able to support a 50 lbs (22.7
kg) static weight.
Figure 2-6
1 Access point quick mount notch
2 Mounting holes
Step 2 Use four customer-supplied screws and optional screw anchors to attach the mounting plate to the
mounting surface.
Note
Cisco Aironet 1520 Series Outdoor Mesh Access Point Hardware Installation Guide
2-18
for the mounting bracket screw hole locations. You can optionally use the individual
Mounting Bracket for Wall Mounting
If necessary, use suitable screw anchors and an exterior-grade plywood backboard to mount the
access point to stucco, cement, or drywall.
Chapter 2
3 Mounting slots (allows bracket rotation)
Mounting Instructions
OL-12632-03