Assembly Instructions - Stamina 40-0058 Owner's Manual

ASSEMBLY INSTRUCTIONS

Place all parts from the box in a cleared area and position them on the floor in front of you. Remove
all packing materials from your area and place them back into the box. Do not dispose of the packing
materials until assembly is completed. Read each step carefully before beginning. If you are missing
a part, please go to staminaproducts.com under the Customer Care section and order the part
needed, e-mail us at customer.care@staminaproducts.com, or call us toll free at 1-800-375-7520
(in the U.S.). Our Customer Care Staff is available to assist you from 7:30 A.M. to 5:00 P.M. (Central
Time) Monday through Thursday and 8:00 A.M. to 3:00 P.M. (Central Time) on Friday.
STEP 1:
Place the STEPPER on the floor as shown in illustration A. Pull the LOCKING PIN(13) from the
MAIN FRAME(17). Unfold the FRONT SUPPORT(18) and lock in position with the LOCKING PIN(13).
STEP 2:
Refer to illustration B. Remove the ADJUSTMENT KNOB(14) from the MAIN FRAME(17). Pull
up the HANDLEBAR POST(10) and lock into place in one of the adjustment holes with the ADJUSTMENT
KNOB(14). Loosen the T KNOB(9) and swing up the HANDLEBAR(3) to the desired angle. Then lock in
position with the T KNOB(9). Refer to illustration C.
NOTE: 1. The pin of the ADJUSTMENT KNOB(14) must be inserted into one of the adjustment holes in
the HANDLEBAR POST(10) and the ADJUSTMENT KNOB(14) must be screwed in tight to
ensure that the HANDLEBAR POST(10) will fit securely in the MAIN FRAME(17).
2. You can adjust the LEVELING CAPS(41) on the stabilizer of the MAIN FRAME(17) to keep the
STEPPER stable.
CAUTION Keep fingers clear of all pinch points when folding and unfolding the STEPPER.
!
A
B
C
7