Channel Scope Mode - AOR SDU5600 Instruction Manual

Professional spectrum display unit for use with a companion receiver

Hide thumbs Also See for SDU5600:

Table of Contents

Enter the Start Frequency and the End (Stop) Frequency using the Special Function

Keys located on the lower side of the LCD display and the numeric keys followed by

the [ENT] key ([KHz] key or [MHz] key.)

[Memo: Displayed frequency range:

Spectrum Analyzer Mode --- CF (Center Frequency) +/- (Frequency span/2)

Step Resolution Mode --- CF (Center Frequency) +/- (Display step x 160)

The Frequency span on the above example: 25 KHz x 320 steps = 8 MHz)

6-6-3 Channel Scope Mode

On the above screen, the following information is displayed.

Start frequency:

Step frequency:

End (Stop) frequency:

Frequency span:

Marker frequency:

Receive marker frequency:119.7 MHz

Unlike the Spectrum Analyzer mode or Step Resolution mode, the CF (Center

Frequency) setting is not available in the Channel Scope Mode.

Start Frequency (Ch. START)

Press the [Ch. START] key using the left Special Function Keys. The icon indicating

the current start frequency will be reversed prompting the entry of new start frequency.

118.0 MHz

25 KHz

122.0 MHz

4 MHz

121.8 MHz

Table of Contents