Table of Contents
Advertisement
• IP Address
• IP Subnet Mask
• Default Gateway
• Primary DNS
• Secondary DNS
• Use Link-Local Address
• IPv6 IP Address
• IPv6 Subnet Prefix Length
• IPv6 Default Gateway
• IPv6 Primary DNS
• IPv6 Secondary DNS
• Accept
• Cancel
4.3.2 Spanning Tree Settings
The Spanning Tree Protocol (STP) allows network to provide a redundant link in the event of a link failure. It is
advised to turn on this option for multi
to turn on this option for multi-point bridge network to avoid network loop.
Click "System
Spanning Tree Settings" to enable/disable Spanning Tree Settings.
Spanning Tree Settings
The page includes the following settings
The page includes the following settings:
The LAN IP of the AP.
The
The default is 192.168.1.253. You can change it according to your need
The default is
The LAN subnet mask of the AP.
The
Enter the Gateway IP address of the AP.
Enter t
Enter the primary DNS server of the AP.
Enter the
Enter the
Enter the secondary DNS server of the AP.
Click to enable a link-local address for the AP.
Click to
Enter the IPv6
Enter the IPv6 LAN IP of the AP.
Enter the secondary DNS server of the AP.
Enter the
Enter the IPv6 Gateway IP address of the AP.
Enter t
Enter the IPv6 primary DNS server of the AP.
Enter the
Enter the IPv6 secondary DNS server of the AP.
Enter the
Click Accept to apply the new settings.
Click
Click
Click Cancel to cancel the unsaved changes and revert to the previous
settings
settings.
Settings
allows network to provide a redundant link in the event of a link failure. It is
allows network to provide a redundant link in the event of a link failure. It is
to enable/disable Spanning Tree Settings.
Figure 4-13 Spanning Tree Settings
User Manual of WAP
. You can change it according to your needs.
cancel the unsaved changes and revert to the previous
-33-
WAP-500N/WBS-500N
Advertisement
Table of Contents
