Re-Covering The Roof - Vaillant auroTHERM VFK 145/2 H Installation Manual

5 Assembly

5.5.8 Re-covering the roof

Fig. 5.38 Adapting the flexible apron
+5°C – +40°C
Fig. 5.39 Sticking the flexible protection
Fig. 5.40 Mounting the foam sealing wedge
36
1
+5°C – +40°C
>10 C
> Remove the protective film from the adhe-
sive surface of the flexible apron
(¬ Table 5.1/5.3, Item 17).
> Adapt the flexible apron to the shape of
the tiles.
> Stick the flexible apron where parts over-
lap (1).
i
Make sure that the adhesive sur-
face is dry and free from dust and
grease.
> As required, (e.g. with high roof tiles)
stick the sealing apron extension under
the flexible apron. Pay attention to the
direction the rain water flows in when
doing this.
> Turn the flexible aprons back at the ends
of the collector array.
i
Make sure that the adhesive sur-
face is dry and free from dust and
grease.
> Stick the foam sealing wedge on the side
sections of the collector frame.
> Stick the foam wedge to the ridge plates.
> If necessary carefully cut the foam sealing
wedge with the utility knife.
i
Make sure that the adhesive sur-
face is dry and free from dust and
grease.
Installation manual auroTHERM 0020100606_02