Attaching Trapezoidal Plates, Connectors, Ridge Sheets And Tile Supports - Vaillant auroTHERM VFK 145/2 H Installation Manual

5 Assembly
Fig. 5.28 Fastening the shorter top side sections
5.5.7 Attaching trapezoidal plates, connectors,
ridge sheets and tile supports
2
3
Fig. 5.29 Attaching the ridge plates
32
2
1
> Remove the film from the short side sec-
tions.
> Slide the short side sections
(¬ Table 5.1/5.3, Item 22/23) over the
1 collectors at the left and right in the
uppermost horizontal row.
> Take care that the respective side section
– rests on the collector frame,
– is pushed together with the lower side
section at the fold (1). Push the fold on
the lower side section apart a little for
this.
> Press the side section on to the side sec-
tion so that it locks.
> Fasten the side sections to the roof bat-
tens with the supplied brackets (2)
(¬ Table 5.1/5.3, Item 31) and No. 2
screws (¬ Table 5.2/5.4) using the Torx
bit.
The trapezoidal plate (1) (¬ Table 5.1/5.3,
Item 27) covers the area (the "cross") in
which the interstices of four collectors meet.
> Slide a trapezoidal plate with the strap
under the vertical intermediate plate (1).
> Slide the trapezoidal plate forward until
the bent edges rest on the horizontal
intermediate plates.
> Drill a hole through the opening at the
upper end of the trapezoidal plate into the
intermediate plates underneath (2).
> Rivet the trapezoidal plate to the interme-
diate plates (3).
Installation manual auroTHERM 0020100606_02