Dell Dimension 9200 Service Manual page 60

Documentation
1 release tabs (2)
4 alignment bar
5. If you are installing a new card, remove the filler bracket to create a card-slot opening. Then continue with
6. If you are replacing a card that is already installed in the computer, remove the card.
If necessary, disconnect any cables connected to the card. Grasp the card by its top corners, and ease it out of its
connector.
7. Prepare the card for installation.
See the documentation that came with the card for information on configuring the card, making internal connections, or
otherwise customizing it for your computer.
CAUTION: Some network adapters automatically start the computer when they are connected to a
network. To guard against electrical shock, be sure to unplug your computer from its electrical outlet
before installing any cards.
8. Place the card in the connector and press down firmly. Ensure that the card is seated fully in the slot.
http://support.dell.com/support/edocs/systems/dim9200/en/SM_EN/parts.htm (13 of 68) [12/9/2007 11:22:24 PM]
2 filler bracket
5 card retention door
3 alignment guide
step 7.