Airstream Excella 1975 Owner's Manual page 54

Table of Contents

Advertisement

Table Opening 1.
as possible towards the back wall. Raise the
rear cushion to its normal position.
To make fixed twin beds, lift mattress slight¬
ly, pull it away from the wall and then tuck
bedding in along wall. Note: Please do not
launder mattress ticking; it has to be dry
cleaned to prevent shrinkage.
To open the table, lift the table into a
horizontal position, depress latch and pull the
folding leg down until it locks in position. To
extend the table pull out on the latch
underneath the table right next to the leg and
lift the table and leg slightly off the floor.
Now pull the extension frame and leg out as
far as they will go. Release the catch on the
extension table leaf and rotate it over onto
the extended frame. By raising the leg the
entire table can be slid forward and aft for
your seating comfort.
2
To stow simply reverse the procedure and
unlock the leg and drop the table to the wall.
Additional storage is provided behind the
table compartment.
The below bed storage is available on fixed
twin models for additional storage of bedding
and linen or fishing and hunting gear.
The hanging wardrobe (optional), located
over the foot of the bed, increases storage for
short items like shirts, blouses, skirts and
short coats.
A space locker attached to the roof lockers is
available for additional storage space for
bedding, etc. in the bedroom.
All the drawers are removable allowing you
storage flexibility and ease of packing and
unpacking. Wardrobe catches are self-locking
and they may be opened by sliding the touch
plate away from the door opening.
When attaching wall hung improvements, like
hooks for clothing, bookshelves and extra
towel racks, secure with half-inch No. 8 sheet
metal screws
with flat binder heads,
make holes in the aluminum inner walls with
a small hand drill (No. 30 drill bit).
The Central Control Panel, located in the
galley roof locker of your unit, contains the
necessary instrumentation to monitor your
Airstream's systems.
The panel light switch lights the gauges.
The battery condition tester has a switch
which operates a meter indicating: Good, fair
and low condition. (This meter does not
indicate true battery state of charge while you
46

Advertisement

Table of Contents
loading

Table of Contents