Samsung SCD6040 Owner's Instruction Book page 162

ENGLISH
Troubleshooting
Display
Slow
CARD ERROR!
Slow
NOT FORMATTED!
✤
If these instructions do not solve your problem, contact your nearest Samsung dealer or authorized service center/personnel.
Symptom
No power is supplied
LCD monitor is blank
DATE/TIME is wrong
Cannot Record a video
Focus does not adjust automatically
Cassette tape will not load properly
The memory card will not load
properly
Color balance of picture is not
natural
158 158
Blinking Informs that
Memory card is formatted by other
device or has error in system folder
Memory card needs to be formatted
Possible Causes
The power is not connected properly
The battery is dead
The battery is too cold
Viewfinder is on.
Multi-AV cable is connected
Display option is turned off
The DATE/TIME is not set
The built-in clock battery has
exhausted.
Protection tab is set to SAVE
Power Switch is set to PLAY
Power Switch is set to
Focus is set to manual mode
Recording was done in a dark place
Lens is covered with condensation
Cassette is in wrong position
The battery is exhausted
Memory card is in wrong position
Something fills in the memory card slot
White balance adjustment is required
Format the memory card using the camera menu
Format the memory card using the camera menu
Connect the AC adapter properly, page 27
Replace the dead battery pack
Warm up the battery or move to warmer place
Close the viewfinder
Remove the cable
Press the DISPLAY button to bring back OSD
Set the DATE/TIME, page 38
Replace the Li-ion battery for built-in clock, page 24
Cancel the protection, page 48
Set the Power Switch to REC
(CAMERA) Set the Mode Dial to
Set focus to AUTO
Use strobe or lit the place
Clear the lens and check the focus
Insert the cassette tape properly, page 47
Charge the battery or use AC adapter
Insert the memory card properly, page 83
Clear the memory card slot
Set proper white balance, page 121
Action
Measure
(MOVIE) mode