Adapter Bracket Assembly Kit Installation Instructions - Fluke Victoreen 190 Operator's Manual

Adapter Bracket Assembly Kit Installation Instructions

C.1 Adapter Bracket Assembly Kit Installation Instructions
1. Remove the adapter bracket assembly kit from the plastic bag.
2. Ensure the following are included:
Item
Adapter bracket assembly (190235)
#6-32 Machine Screws
#6 Split Washers
# 6-32 Hex Nuts
3. Align the three holes on the side of the adapter bracket assembly (190235) with the three holes on
the right side of the adapter stand (190213).
4. Mount the adapter bracket assembly to the adapter stand using the three sets of machine screws,
washers, and nuts. Be sure to place the hex nuts on the inside of the stand. Hand tighten the
screws using a screwdriver.
5. The frisker probe can be placed in the adapter bracket assembly clip.
6. Tension on the clip can be adjusted by widening or squeezing close the spring clip opening.
This completes the assembly instructions.
Adapter Bracket Assembly Kit Installation Instructions
You are not required to mount the adapter bracket
assembly to the adapter stand. If you choose to
mount the adapter bracket assembly to the adapter
stand, please perform the following;
NOTE
Qty
1
3
3
3
Appendix
C
Appendix C
C-1