Advertisement
Quick Links
B150 Direct Plumb Kit Installation
Quick Start Guide
NOTE:
The B150 Brewer is designed to fill in 90 seconds.
Depending on water pressure and voltage variations
the brewer may time out during fill. If this occurs just
flip the on/off switch – restarting the brewer.
Make sure to disconnect the brewer from
1
AC power supply and drain the internal
Hot Water Tank if previously filled.
2
Remove the Cold Water Tank from the Brewer.
Turn the Brewer on its left side and remove the 2 high-
3
lighted screws (Screw A)- reserve the 2 screws for later
use when attaching the Direct Plumb Kit.
4
Turn the B150 Brewer right side up. Press on one end of
the Base Plate to release and remove.
Advertisement
Related Manuals for Keurig B150
Summary of Contents for Keurig B150
- Page 1 Turn the Brewer on its left side and remove the 2 high- lighted screws (Screw A)- reserve the 2 screws for later use when attaching the Direct Plumb Kit. Turn the B150 Brewer right side up. Press on one end of the Base Plate to release and remove.
- Page 2 Remove the Connector Cover on the side of the Brewer with a screw driver- Reserve the screw (Screw B) for later use when re-attaching the Connector Cover. Set the B150 Direct Plumb Kit on the Base and plug-in the electrical connection from the Direct Plumb Kit to the Brewer.