Configuring System Message Logging To A File - Cisco Nexus 3548 series Configuration Manual

Configuring System Message Logging
switch# configure terminal
switch(config)# logging console 3
The following example shows how to display the console logging configuration:
switch# show logging console
Logging console:
The following example shows how to disable logging for the console:
switch# configure terminal
switch(config)# no logging console
The following example shows how to configure a logging level of 4 for the terminal session:
switch# terminal monitor
switch# configure terminal
switch(config)# logging monitor 4
The following example shows how to display the terminal session logging configuration:
switch# show logging monitor
Logging monitor:
The following example shows how to disable logging for the terminal session:
switch# configure terminal
switch(config)# no logging monitor

Configuring System Message Logging to a File

You can configure the switch to log system messages to a file. By default, system messages are logged to the
file log:messages.
Procedure
Step 1
Step 2
enabled (Severity: error)
enabled (Severity: warning)
Command or Action
switch# configure terminal
switch(config)# logging logfile logfile-name
severity-level [size bytes]
Cisco Nexus 3548 Switch NX-OS System Management Configuration Guide, Release 7.x
Configuring System Message Logging to a File
Purpose
Enters global configuration mode.
Configures the name of the log file used to store
system messages and the minimum severity
level to log. You can optionally specify a
maximum file size. The default severity level
is 5 and the file size is 4194304.
Severity levels range from 0 to 7:
• 0 – emergency
• 1 – alert
39