Configuring Netware - Samsung SCX-5115 User Manual

A.10
I N
NSTALLING A

Configuring Netware

On IPX/SPX protocol networks (for example, Novell NetWare),
the format of network communication frames must be specified
on the printer. In most cases, you can keep the default setting
on "AUTO." However, you can manually set the frame type
format if required.
• AUTO (default): Automatically senses and limits the frame
type to the first one detected.
• IEEE802.3: Limits the frame type to IPX over IEEE 802.3
frames. All others are discarded.
• ETHERNET II: Limits the frame type to IPX over Ethernet
Frames. All others are discarded.
• IEEE802.2: Limits the frame type to IPX over IEEE 802.2 with
IEEE 802.3 frames. All others are discarded.
• SNAP: Limits the frame type to IPX over SNAP with IEEE
802.3 frames. All others are discarded.
Take the following steps to change the frame type format:
1
Press Menu/Exit and then System Setup on the one-
touch dial keypad. SCX-5115 users should press Menu and
then Enter.
2
Press or
3
Press or
bottom line.
4
Press Mode/Enter (Enter for SCX-5115) to access the
menu.
5
Press or
6
Press Mode/Enter (Enter for SCX-5115).
7
Press or
press Mode/Enter (Enter for SCX-5115).
If you don't want to enable the Netware protocol,
select "OFF".
8
To return to Standby mode, press Stop/Clear.
O
ETWORK PTION
to display "NETWORK SETUP" on the top line.
to display "CONFIG NETWORK" on the
to display "NETWARE" on the bottom line.
to select the frame type you want to set and