Heating Your Room - Samsung ACH1800E Owner's Instructions Manual

Heating Your Room

You must select the HEAT mode if you wish to adjust the :
Heating temperature
Fan speed when heating
1 If necessary, press (ON/OFF) button.
Result: The On/Off indicator on the unit comes on.
The air conditioner runs in the mode selected when
the unit was last used.
The indoor unit beeps.
IMPORTANT
The air conditioner is fitted with a protection mechanism to
prevent the unit from being damaged when it is started
immediately after being:
Plugged in
Stopped
lt will start up normally after three minutes.
2
To select the HEAT mode, press the Mode button until
at the top of the wireless remote controller.
Result: The indoor unit beeps.
The air conditioner runs in HEAT mode.
You can change modes at any time.
N N N N o o o o t t t t e e e e
3
To adjust the temperature, press the Temperature buttons one or more
times until the required temperature is displayed. Possible temperatures
O
are between 16 C and 30
Result: Each time you press Temperature buttons:
- The temperature is adjusted by 1
- The indoor unit beeps.
The air conditioner starts heating, provided that the room
temperature is lower than the selected temperature ; the fan
will, however, operate.
4 Select the fan speed by pressing the Fan button one or more times until
the intended value is displayed :
Automatic(rotated :
Low
Medium
High
5
To control the direction of the air flow, refer to page 25.
O
C inclusive.
O
C.
)
is displayed
23
E-