Function Added To Synchronize With Smpte Timecode And Play The Current Take - Tascam DA-6400 Manual

SRC
This turns the sample rate converter on/off for each signal line
Options: (default value),
OFF
NOTE
cannot be set to
i
SRC ON
master clock. In this case, the following pop-up window ap-
pears.A confirmation pop-up message appears.
i If an IF-AE16 is installed, depending on the main unit
item setting and clock master setting, an error described as
"SRC for the IF-AE16 signal line selected as the CLOCK MASTER
is ON" could occur.
In this case, the item for that signal line will be turned
SRC

Function added to synchronize with SMPTE timecode and play the current take

A function has been added to play the current take synchronized
with the SMPTE timecode input through the TIMECODE IN con-
nector on the back of the unit.
A page has been added to the menu for this function.
TC SYNC
Setting timecode synchronized playback
Use the page to make timecode synchronized play-
TC SYNC
back settings.
TC CHASE MODE
Turn timecode synchronized operation on/off.
Options:
(default value),
OFF
NOTE
You can also press the 9 [CHASE] button while pressing and
holding the SHIFT button on the front of the unit to turn it
on/off.
DA-6400/DA-6400dp
ON
for the signal line selected as the
ON
off automatically and the INFO indicator will light red. In this
situation, press the INFO button to open the following alert
message. Once this has been confirmed, it will disappear.
i The INFO indicator lights red when an error has occurred with
the IF-AE16 input signal. In this situation, press the INFO but-
ton to show the following information. Note that even if there
is an error with the input signal, it will not mute.
Unlocked: The input signal is not synchronized with the main
unit.
SRC
no signal: There is no input signal.
not audio: The input signal Cbit data is "not audio".
Dual Line: The input signal Cbit data is "Dual Line".
TC CHASE OFFSET
A timecode offset can be set for the input timecode.
The setting range is from
Function (default value)
TC RECHASE MODE
This turns on/off the resynchronization function for when syn-
chronization becomes inaccurate during timecode synchro-
nized playback.
Options:
OFF
When set to
OFF
timecode is ignored and the unit operates in free run mode.
When set to
ON
inaccuracy exceeds the threshold level set on the
CHASE THRESH
to
-23:59:59.29 +23:59:59.29
(default value),
ON
, after being synchronized once the input
, rechasing will start when the synchronization
screen.
TASCAM DA-6400/DA-6400dp
.
TC RE-
29