Questions & Answers - Siemens S75 Manual

of S75 MINOS, w/o ptt, FCC, us-en, (24.10.2005, 13:42)
left page (122)
122 Questions & Answers
Questions & Answers
If you have any questions about using your phone, visit us anytime at
www.siemens.com/mobilephonescustomercare.For additional help, we have listed
below some frequently asked questions and answers.
Configuration service
To help you set up your mobile phone for the data service WAP, MMS, e-mail and Internet,
you can use a configuration service. This service is used to have the necessary settings for
your mobile phone sent to you by SMS. We recommend that you contact your network
provider who will send you the configuration messages.
As an alternative you can also use the "Setting Configurator" at
www.siemens.com/mobilephonescustomercare. Siemens will then send you the
configuration messages. Please follow the instructions contained in those messages.
Problem
Phone cannot be
switched on.
Standby time is too
short.
Charging error
(charge icon not
displayed).
Poss. causes
On/Off key not pressed long
enough.
Flat battery.
Battery contacts dirty.
See also below under
"Charging error".
Frequent use of organiser
and games.
Fast search activated.
Display illumination
switched on.
Unintentional keystrokes
(illumination!).
Battery totally discharged.
Temperature out of range:
5 °C to 45 °C
(+41°F to +113°F).
Contact problem
No mains voltage.
Wrong charger.
Battery faulty.
Possible solution
Press On/Off key for at least 2 seconds.
Charge battery. Check charging indicator in the display.
Clean contacts.
Restrict use if applicable.
Deactivate speed search (page 94).
Switch off display illumination (page 75).
Switch on Auto key lock (page 91).
1) Plug in charger cable, battery is on charge.
2) Charge icon appears after approx. 2 hours.
3) Charge battery.
Make sure the ambient temperature is right, wait for a
while, then recharge.
Check power supply and connection to the phone.
Check battery contacts and telephone connection sock-
et, clean them if necessary, then insert battery again.
Use different mains power socket, check mains voltage.
Only use original Siemens accessories.
Replace battery.