Rear Panel Layout - Samson S.zone S Class Owner's Manual

Rear Panel Layout

AC INPUT FUSE HOLDER – Connect the supplied 3-
A
pin IEC power cable here.
ZONE 1 OUTPUT – This connector includes the Zone
B
1 Left and Right balanced output connections, along
with the connections for the REMOTE volume con-
trol.
ZONE 2 OUTPUT – This connector includes the Zone
C
2 Left and Right balanced output connections, along
with the connections for the REMOTE volume control.
ZONE 3 OUTPUT – This connector includes the Zone
D
3 Left and Right balanced output connections, along
with the connections for the REMOTE volume control.
ZONE 4 OUTPUT – This connector includes the Zone
E
4 Left and Right balanced output connections, along
with the connections for the REMOTE volume control.
LINE 3 AND 4 INPUT - This connector is used to
F
hook up the LINE 3 and 4 Left and Right input con-
nections.
DUCK TRIM – This rotary control is used to adjust
G
how much signal level is dropped when the micro-
phone activates the DUCK circuit.
MIC/LINE 2 – This connector includes the connec-
H
tion for a stereo line level and mono microphone
input for channel 2.
Controls and Functions
MIC TRIM – The rotary control is used to adjust
I
the input sensitivity of the microphone pre
amplifier on channel 2.
MIC/LINE 1 – This connector includes the con-
J
nection for a stereo line level and mono micro-
phone input for channel 1.
MIC TRIM – The rotary control is used to adjust
K
the input sensitivity of the microphone pre
amplifier on channel 2.
CH 1 MASTER switch – This switch is used to
L
enable the ducking function on channels 2, 3
and 4.
DUCK ENABLE– Channel 2 will act as a ducking
M
master when this switch is pressed in and the
volume of channels 3 and 4 will automatically
be lowered when the there is a microphone
signal on Channel 2.
N DUCK ENABLE – Channel 1 will act as a duck-
ing master when this switch is pressed in and
the volume of channels 3 and 4 will automati-
cally be lowered when the there is a micro-
phone signal on Channel 1.
5